Jump to content


  • Posts

  • Joined

  • Last visited

  • Days Won


nano31 last won the day on July 21 2013

nano31 had the most liked content!

1 Follower

Profile Information

  • Gender
  • Location
    Southern Provience
  • Interests
    Motor Mechanics, Computers, Driving,Studying

My Vehicle Details

  • Vehicle Make
  • Vehicle Model
    Corolla CE 110
  • Engine Type
  • Mechanical Mods
    Keep it as original as possible
  • Cosmetic Mods
    Keep it as original as possible
  • Future Plans
    Carina 3C Diesel
  • General Comments
    Vehicle is not worth as any living being but you should treat your vehicle as if it is a living being

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

nano31's Achievements


Newbie (1/14)



  1. Yes, very hard to find good condition CR42 these days, most of them were abused already. It has very high market these days! Nothing done on the injector pump
  2. No black smoke at all, even at high rev All filters replaced with originals Engine heat about half of the max
  3. I have recently got townace CR42 (original diesel, Auto, 3C EFI,NON turbo YOM 2006, milage 180k) got follwing issue. 1). I can not speed up above 100km/h I tried in express way but it kinda holding at 100km/h, no excessive engine noise/Revolution. Compaired with my good old CE110 auto, in which there is shifting to OD at 85km/h and can easily accelerate up to 140km/h but I can not feel the OD in my CR42 Apart from the apparent OD issue no other auto gear issue and gears are shifting smoothly. I have changed the ATF. Engine is not burning oil and in good condition 2.) Engine is not "racing" however much I pressed the paddle in the morning. Say if there is a uphill, van is very slowly moving with less engine acceleration inspite of the pressure on the accelerator but this soon fade after engine heatup.
  4. lol..I have easily passed them down (panda) with my 19yr old CE110 in E1
  5. ATF change would not completely cure the current problem you are experiencing yet will settle the symptoms! It will appear in few months time. Internal rubber oil seals are failing. But change the oil and watch full waiting is advised as it is cost effective at present and keep some money ready for near future GB repair.
  6. Just check around the compressor and see if there is any oil leaks (AC gas is mixed with oil and oil leak indicate a gas leak) around the compressor. Is it gradual slow leak or sudden leak?
  7. Internal o rings of the box might have gone. Better contact Chandana
  8. After all I wanted to replace vacuum pump as there is nothing to change except ABS unit and brake lines which seems ok. Gotta one Rs 4000/=. All Brake issues are gone I should have done it early...
  9. Nice pair of horn...what is the brand? I use mitsuba alpha with the stock relay
  10. Does it have bleeding plug? What we did was reverse bleeding and vaccum bleeding
  11. Pistop doesnt have that tool anymore. Did vaccum bleeding and reverse bleeding, some amount of air bubbles came out. Brake power improved. Still seems the initial few inches of brake paddle movement produse very little brake but at the last few inches have good brake power.
  12. Thanks for advise , that is what I am going to do
  13. ABS unit was not emptied deleberately and each and every time the MC also bench blead. Need to try scan tool with vaccum method.
  14. Brake paddle is somewhat low still. Need to try vaccum method, it seems the vaccum pump used to bleed brake is a simple hand operated vaccum pump.
  15. Not only the MC but all four wheel cylinders have been replaced, brake oil is very clean.
  • Create New...