here's my engine guy Kelum working on the block. the bearings are in. he's bolting the flywheel to finish it off. next up, the piston chambers. that should be worked on today, methinks.

closer with each passing day. so today met up with kelum again. he had finished the block, and put the piston rings in with the cleaned pistons:

here's the before:

and this is the after:

and started working on the valve ports. so much gunk in there. unbeleivable. cleaned all of it out. bugger too his time doing this. nice to see some dedication!

and a few more pieces have gone into the engine bay. electricals mostly. fuse boxes et al. i guess you have to be as fanatical as i am to notice a little difference from last time

going to spend the whole of monday there. so lots more to update